Home › States › Massachusetts › pH (Acidic or Basic Water)

pH (Acidic or Basic Water) in Massachusetts Wells

Everyday problem 9 of 9 counties where it is common in tested wells Compared with the recommended pH range (6.5 to 8.5)
Highest Barnstable County 94% of 53 well sites high in it
Testing strongly recommended Test your well →Mail-in kit sold on Amazon, results in about a weekFind a certified lab

County by county

Every Massachusetts county where wells were tested for pH. Tap a column name to sort. Counties use different tests (some only test wells when homes are sold, and some state programs test wells people chose to send), so open a county to see which wells, years and limit. For pH in every state we cover, see our pH (Acidic or Basic Water) guide.

CountyHigh in itTestedHow commonConfidence
Barnstable County94%53 well sitesVery commonModerate
Bristol County71%7 wellsVery commonLow
Essex County33%9 wellsVery commonLow
Franklin County17%6 wellsCommonLow
Hampden County18%11 wellsCommonLow
Hampshire County50%6 wellsVery commonLow
Middlesex County62%13 well sitesVery commonLow
Plymouth County90%19 well sitesVery commonLow
Worcester County35%40 well sitesVery commonModerate

What it does

Water that is too acidic can corrode pipes, leave blue-green stains and pull lead and copper from plumbing into your water. Water that is too basic can taste bitter and leave scale. Source

Where it comes from: It depends on the rock and soil around your well.

How to test for pH

A county's results can't tell you what is in your own well; only a test can. Ask a certified lab for a pH test, or use a mail-in kit that lists it. Each county page lists the certified labs nearest you.

How to fix acidic (low pH) well water

Most homes fix acidic water with a neutralizing filter: a tank of crushed limestone (calcite) or magnesium oxide that raises the pH as water passes through. Very acidic water, or a home that uses a lot of water, may do better with a pump that adds soda ash instead. Test your tap water for lead and copper too, because acidic water can pull them from pipes.

OptionWhat to know
Neutralizing filter (calcite or magnesium oxide)Raises pH and adds some hardness, which helps stop corrosion. The media wears away and has to be refilled every few weeks to months.
Chemical feed pump (soda ash)Adds soda ash before the pressure tank, so it protects the tank and pipes too. It doesn't add hardness, but it adds a little sodium.

In what order

  • Fix pH before an iron filter. Some iron filters need a pH of at least 6.8 to remove iron, and 7.5 to remove manganese.
  • Test first-draw tap water (the first water out in the morning) for lead and copper at a certified lab.

Sources: Penn State Extension, Corrosive Water Problems; Penn State Extension, Iron and Manganese in Private Water Systems. This is general information, not professional advice: check with a licensed water treatment installer or well contractor before you buy or install anything.

If your own test shows pH over the limit, these are common fixes:

A neutralizing filter fixes acidic water.

Got your test results?

Type in the numbers from your lab report and get a plan: what to fix first, in what order, and what you don't need to buy. Free. Your numbers stay in your browser.

Make a treatment plan